Advanced Journal of Environmental Science and Technology

ISSN 2756-3251

Advanced Journal of Environmental Science and Technology | Vol. 17 (7), pp. 204-218, July, 2026

Research Article

Electrospun Polyimide-Boron Nitride Aerogel Membranes Filter High-Temperature Industrial Flue Gas Particulates Above 350 °C

Kenji Morita¹*, Nadia El-Khoury², David Novak³

¹Department of Chemical System Engineering, University of Tokyo, Tokyo, Japan
²Department of Chemical and Petroleum Engineering, American University of Beirut, Beirut, Lebanon
³Department of Materials Engineering, Brno University of Technology, Brno, Czech Republic

Corresponding Author: Kenji Morita — [email protected]

Abstract

Exhaust gases from cement kilns and metallurgical smelters exceed 350 °C, forcing operators to cool gas streams before filtration and wasting recoverable thermal energy. We fabricated thermally stable fibrous aerogel membranes by electrospinning aromatic polyimide nanofibers reinforced with hexagonal boron nitride (h-BN) nanosheets. The composite membrane retained full tensile flexibility at 400 °C and captured 99.92% of submicron fly-ash particulates (PM0.5) at a low pressure drop of 82 Pa. Pulse-jet backflushing restored 98% of initial permeability across 500 high-temperature filtration cycles without thermal embrittlement.

Keywords: high-temperature filtration; polyimide aerogel; hexagonal boron nitride; industrial flue gas; particulate matter capture; waste heat preservation

Manuscript Timeline: Received 22 June, 2026; Revised 19 July, 2026; Accepted 29 July, 2026; Published 30 July, 2026.

Citation: Morita, K., El-Khoury, N., and Novak, D. (2026). Electrospun Polyimide-Boron Nitride Aerogel Membranes Filter High-Temperature Industrial Flue Gas Particulates Above 350 °C. Advanced Journal of Environmental Science and Technology, 17(7), pp. 204-218.