ISSN 2756-3251
Advanced Journal of Environmental Science and Technology | Vol. 17 (6), pp. 376-388, June, 2026
Research Article
Circular Upcycling of Waste Wind Turbine Blades via Solvolytic Resin Depolymerization and Recovered Glass Fiber Reinforcement in Recycled Polypropylene Composites
Henrik Lindholm¹*, Meera Subramanian², Alejandro Silva³
¹Department of Wind and Energy Systems, Technical University of Denmark, Roskilde, Denmark
²Department of Polymer and Process Engineering, Indian Institute of Technology Roorkee, Roorkee, India
³Department of Mechanical Engineering, National Autonomous University of Mexico, Mexico City, Mexico
Corresponding Author: Henrik Lindholm — [email protected]
Abstract
Decommissioned glass-fiber-reinforced epoxy wind turbine blades pose a growing composite waste challenge because thermoset polymer matrices resist conventional remelting. This study demonstrates a mild, catalyst-assisted supercritical ethanol-water solvolysis process (260 °C, 90 minutes) that selectively cleaves amine-cured epoxy crosslinks to reclaim clean, full-length glass fibers alongside reusable bisphenol-based oligomers. Recovered glass fibers retained 93% of virgin tensile strength and were compounded at 30 wt% loading into post-consumer recycled polypropylene using maleic-anhydride coupling agents. The resulting thermoplastic composites exhibited a 165% increase in flexural modulus suitable for structural automotive and railway sleepers, while cradle-to-gate life-cycle assessment showed a 67% reduction in carbon footprint compared to landfilling and virgin fiberglass manufacturing.
Keywords: wind turbine blade recycling; chemical solvolysis; glass fiber recovery; thermoset composites; circular economy; life-cycle assessment
Manuscript Timeline: Received 25 May, 2026; Revised 18 June, 2026; Accepted 27 June, 2026; Published 30 June, 2026.
Citation: Lindholm, H., Subramanian, M., and Silva, A. (2026). Circular Upcycling of Waste Wind Turbine Blades via Solvolytic Resin Depolymerization and Recovered Glass Fiber Reinforcement in Recycled Polypropylene Composites. Advanced Journal of Environmental Science and Technology, 17(6), pp. 376-388.
Subscribe to read the full article: https://www.internationalscholarsjournals.org/subscribe-to-read