Advanced Journal of Environmental Science and Technology

ISSN 2756-3251

Table of Contents 2026

Advanced Journal of Environmental Science and Technology | Vol. 17 (5), pp. 422-433, May, 2026

Short Communication

Biodegradable Chitin-Cellulose Aerogel Sponges Derived from Seafood and Forestry Byproducts for High-Capacity Marine Oil Spill Recovery

Soraia Tavares¹*, Anders Solberg², Putri Wulandari³

¹Department of Chemistry, University of Aveiro, Aveiro, Portugal
²Department of Chemical Engineering, Norwegian University of Science and Technology, Trondheim, Norway
³Department of Marine Science and Technology, IPB University, Bogor, Indonesia

Corresponding Author: Soraia Tavares — [email protected]

Abstract

Synthetic polypropylene oil-sorbent booms used in marine spill response generate persistent microplastic debris and require energy-intensive incineration after single use. This study fabricates superhydrophobic, oleophilic aerogel sponges via freeze-casting deacetylated shrimp-shell chitin nanofibers with softwood cellulose nanocrystals crosslinked by citric acid and coated with a plant-derived beeswax-stearic acid layer. Exhibiting an ultralow density of 11.8 mg/cm3 and 99.2% porosity, the bio-aerogel absorbed 68 to 94 times its own weight in crude oil, marine diesel, and weathered bunker fuel within 45 seconds while repelling seawater (water contact angle 154°). Mechanical squeezing recovered 91% of absorbed oil over 25 reuse cycles, and spent sponges underwent 89% soil biodegradation within 60 days, offering a circular alternative for marine spill response.

Keywords: oil spill remediation; biodegradable aerogels; chitin nanofibers; cellulose nanocrystals; circular bioeconomy; marine pollution

Manuscript Timeline: Received 24 April, 2026; Revised 19 May, 2026; Accepted 29 May, 2026; Published 31 May, 2026.

Citation: Tavares, S., Solberg, A., and Wulandari, P. (2026). Biodegradable Chitin-Cellulose Aerogel Sponges Derived from Seafood and Forestry Byproducts for High-Capacity Marine Oil Spill Recovery. Advanced Journal of Environmental Science and Technology, 17(5), pp. 422-433.

Advanced Journal of Environmental Science and Technology | Vol. 17 (5), pp. 434-446, May, 2026

Research Article

Ultrafiltration Forward Osmosis Hybrid Membranes Functionalized with Zwitterionic Carbon Quantum Dots for Zero-Liquid-Discharge Textile Dye Wastewater Reclamation

Meera Krishnan¹*, Jakub Nowak², Camila Herrera³

¹Department of Chemical Engineering, Anna University, Chennai, India
²Faculty of Environmental Engineering, Wroclaw University of Science and Technology, Wroclaw, Poland
³Department of Hydraulic and Environmental Engineering, Pontifical Catholic University of Chile, Santiago, Chile

Corresponding Author: Meera Krishnan — [email protected]

Abstract

High-salinity reactive dye effluents discharged by textile manufacturing facilities cause severe aquatic light attenuation and toxic aromatic amine accumulation while resisting conventional biological treatment. This study fabricates a thin-film nanocomposite forward osmosis (FO) membrane incorporating zwitterionic nitrogen-sulfur co-doped carbon quantum dots within a polyamide selective layer coupled to a solar-driven membrane distillation draw recovery loop. Under cross-flow testing using real mercerization and reactive dyeing wastewater, the modified membrane achieved a water flux of 28.4 LMH alongside 99.8% rejection of Reactive Black 5 and 97.6% rejection of divalent salts. Zwitterionic hydration shells suppressed organic dye cake formation, maintaining 91% flux recovery after hydraulic flushing over 160 operating hours and enabling closed-loop reuse of both purified process water and concentrated sodium sulfate bath salts.

Keywords: forward osmosis; carbon quantum dots; textile wastewater; zero liquid discharge; antifouling membranes; resource recovery

Manuscript Timeline: Received 17 April, 2026; Revised 13 May, 2026; Accepted 25 May, 2026; Published 31 May, 2026.

Citation: Krishnan, M., Nowak, J., and Herrera, C. (2026). Ultrafiltration Forward Osmosis Hybrid Membranes Functionalized with Zwitterionic Carbon Quantum Dots for Zero-Liquid-Discharge Textile Dye Wastewater Reclamation. Advanced Journal of Environmental Science and Technology, 17(5), pp. 434-446.

Advanced Journal of Environmental Science and Technology | Vol. 17 (5), pp. 410-421, May, 2026

Research Article

Perovskite-Silicon Tandem Solar Modules: Accelerated Damp-Heat Degradation Pathways and Lead-Sequestering Encapsulation for End-of-Life Environmental Safety

Lukas Hartmann¹*, Mei-Hua Lin², Diego Castillo³

¹Department of Sustainable Systems Engineering, University of Freiburg, Freiburg, Germany
²Department of Materials Science and Engineering, National Tsing Hua University, Hsinchu, Taiwan
³Institute of Renewable Energies, National Autonomous University of Mexico, Temixco, Mexico

Corresponding Author: Lukas Hartmann — [email protected]

Abstract

Monolithic perovskite-silicon tandem photovoltaics exceed 31% power conversion efficiency, yet operational moisture ingress and potential lead (Pb) leakage during severe hail damage pose environmental barriers to commercial deployment. This investigation evaluates a self-healing phosphonic-acid-functionalized polyolefin elastomer (POE) encapsulant paired with edge-sealed butyl barriers under IEC 61215 accelerated damp-heat (85 °C, 85% relative humidity) and simulated hail-impact rainwater leaching tests. The functionalized encapsulant retained 96.4% of initial tandem efficiency after 2,000 hours of damp-heat exposure by passivating halide-vacancy-induced interfacial recombination. Under standardized fractured-module rainfall simulation (pH 4.2), chelation binding within the POE matrix immobilized 99.6% of soluble lead ions, maintaining leachate concentrations below 4.8 μg/L—well under World Health Organization drinking water thresholds.

Keywords: perovskite-silicon tandem solar cells; lead sequestration; photovoltaic encapsulation; damp-heat stability; ecotoxicity; clean energy technology

Manuscript Timeline: Received 22 April, 2026; Revised 18 May, 2026; Accepted 29 May, 2026; Published 31 May, 2026.

Citation: Hartmann, L., Lin, M.-H., and Castillo, D. (2026). Perovskite-Silicon Tandem Solar Modules: Accelerated Damp-Heat Degradation Pathways and Lead-Sequestering Encapsulation for End-of-Life Environmental Safety. Advanced Journal of Environmental Science and Technology, 17(5), pp. 410-421.

Advanced Journal of Environmental Science and Technology | Vol. 17 (5), pp. 397-409, May, 2026

Research Article

Low-Cost IoT Aerosol Sensor Networks and Physics-Informed Neural Networks for Hyperlocal PM2.5 Source Apportionment in Sub-Saharan Megacities

Ibrahim Musa¹*, Eleanor Vance², Sandeep Kulkarni³

¹Department of Physics, Ahmadu Bello University, Zaria, Nigeria
²School of Earth and Environment, University of Leeds, Leeds, United Kingdom
³Centre for Environmental Science and Engineering, Indian Institute of Technology Delhi, New Delhi, India

Corresponding Author: Ibrahim Musa — [email protected]

Abstract

Rapidly growing Sub-Saharan African cities face severe fine particulate matter (PM2.5) air pollution, yet sparse reference monitoring networks obscure neighborhood-level exposure disparities and emission sources. This study deployed 85 solar-powered optical particle counter nodes integrated with gas-phase sensors across Lagos, calibrated against gravimetric reference samplers using relative-humidity-corrected machine learning algorithms. Coupling multi-sensor time series with a physics-informed neural network (PINN) incorporating urban boundary-layer meteorology resolved spatial source contributions at 250-meter resolution. Source apportionment attributed 38% of ambient PM2.5 to diesel generator and vehicular exhaust, 29% to open solid waste and biomass burning, 21% to windblown crustal dust, and 12% to industrial emissions. High-temporal-resolution diurnal mapping pinpointed nocturnal waste-burning corridors, providing municipal environmental agencies with targeted enforcement metrics.

Keywords: PM2.5 source apportionment; low-cost air sensors; physics-informed neural networks; urban air quality; Sub-Saharan Africa; exposure mapping

Manuscript Timeline: Received 21 April, 2026; Revised 17 May, 2026; Accepted 28 May, 2026; Published 31 May, 2026.

Citation: Musa, I., Vance, E., and Kulkarni, S. (2026). Low-Cost IoT Aerosol Sensor Networks and Physics-Informed Neural Networks for Hyperlocal PM2.5 Source Apportionment in Sub-Saharan Megacities. Advanced Journal of Environmental Science and Technology, 17(5), pp. 397-409.

Advanced Journal of Environmental Science and Technology | Vol. 17 (5), pp. 384-396, May, 2026

Review Article

Mycoremediation of Persistent Organic Pollutants in Contaminated Soils: Enzymatic Mechanisms, Bioavailability Constraints, and Field-Scale Reactor Designs

Marta Kowalczyk¹*, Kofi Boateng², Luis Fernando Torres³

¹Department of Environmental Biotechnology, University of Warmia and Mazury, Olsztyn, Poland
²Department of Environmental Science, University of Cape Coast, Cape Coast, Ghana
³Center for Research and Advanced Studies, National Polytechnic Institute, Mexico City, Mexico

Corresponding Author: Marta Kowalczyk — [email protected]

Abstract

Ligninolytic white-rot fungi secrete nonspecific extracellular oxidoreductases—including laccase, manganese peroxidase, and lignin peroxidase—capable of degrading recalcitrant polychlorinated biphenyls, dioxins, and organochlorine pesticides that resist bacterial metabolism. This review evaluates recent advances in soil mycoremediation, bridging molecular enzymatic mechanisms with practical field-scale engineering strategies. Key mass-transfer limitations arising from pollutant sequestration within soil micropores and humic fractions are examined alongside targeted interventions, including biosurfactant co-amendment and lignocellulosic pellet encapsulation to sustain fungal colonization against indigenous soil microflora competition. Comparative analysis of biopile, myco-barrier, and slurry-phase bioreactor deployments demonstrates up to 84% contaminant mineralization over 120 days when moisture, carbon-to-nitrogen ratios, and redox conditions are dynamically regulated, providing actionable design parameters for full-scale site remediation.

Keywords: mycoremediation; white-rot fungi; persistent organic pollutants; ligninolytic enzymes; soil remediation; bioreactors

Manuscript Timeline: Received 20 April, 2026; Revised 16 May, 2026; Accepted 27 May, 2026; Published 31 May, 2026.

Citation: Kowalczyk, M., Boateng, K., and Torres, L. F. (2026). Mycoremediation of Persistent Organic Pollutants in Contaminated Soils: Enzymatic Mechanisms, Bioavailability Constraints, and Field-Scale Reactor Designs. Advanced Journal of Environmental Science and Technology, 17(5), pp. 384-396.

Advanced Journal of Environmental Science and Technology | Vol. 17 (5), pp. 372-383, May, 2026

Research Article

Capacitive Deionization with Asymmetric MXene/Activated Carbon Electrodes for Selective Nitrate Removal and Fertilizer Recovery from Agricultural Drainage Water

Xiao-Feng Zhang¹*, Amirhossein Tehrani², Rachel Goldstein³

¹School of Environment, Tsinghua University, Beijing, China
²Department of Civil and Environmental Engineering, University of Waterloo, Waterloo, Canada
³Zuckerberg Institute for Water Research, Ben-Gurion University of the Negev, Beersheba, Israel

Corresponding Author: Xiao-Feng Zhang — [email protected]

Abstract

Agricultural tile drainage introduces excess nitrate into surface waters, triggering eutrophication and groundwater contamination while squandering reactive nitrogen fertilizers. This research fabricates an asymmetric flow-electrode capacitive deionization (FCDI) cell pairing a quaternary-ammonium-functionalized Ti3C2Tx MXene anode with a nitrogen-doped activated carbon cathode for selective nitrate electrosorption and recovery. Operating at 1.2 V across multi-ion agricultural drainage containing competing chloride, sulfate, and bicarbonate anions, the functionalized MXene interface exhibited a nitrate selectivity coefficient of 6.4 over chloride and a desalination capacity of 48.7 mg NO3-/g. Polarity-reversal regeneration concentrated captured nitrate into a 1,450 mg/L nutrient-rich brine suitable for direct fertigation reuse, achieving 88.5% charge efficiency at an energy consumption of 0.42 kWh per kilogram of removed nitrate.

Keywords: capacitive deionization; MXene electrodes; nitrate removal; nutrient recovery; agricultural drainage; selective electrosorption

Manuscript Timeline: Received 19 April, 2026; Revised 15 May, 2026; Accepted 27 May, 2026; Published 31 May, 2026.

Citation: Zhang, X.-F., Tehrani, A., and Goldstein, R. (2026). Capacitive Deionization with Asymmetric MXene/Activated Carbon Electrodes for Selective Nitrate Removal and Fertilizer Recovery from Agricultural Drainage Water. Advanced Journal of Environmental Science and Technology, 17(5), pp. 372-383.